Workrite 2421-17TG Gemini Arm Slide - Manual (Page 3)

Gemini Arm Slide Kit Installation Instructions
www.workriteergo.com 800.959.9675
4
3
Attach the Glide Tracks to Table
With 1/8" drill bit, drill 8 holes for each
track (16 total). Use the tracks as a
guide for the drill.
Be careful not to drill all the
way through the table top!
Attach both glide tracks onto the table
with the wood screws included.
Position the Glide Tracks
If possible, remove the table
surface and place it upside
down before mounting the
Gemini Slide Kit.
Place the Gemini Slide Kit on
the tabletop. Position the
tracks so that the fronts are
aligned with each other and
are within 1 inch from the
table edge.
Attach the Keyboard Platform
Mount your keyboard platform onto the
Gemini Arm with four #12 3/4" wood
screws.
If installing a WorkRite platform, use
fasteners supplied with platform.
2
IMPORTANT
The glide tracks must
be parallel for the Slide
Kit to function.
!
up to 1"
1/8"
A A
A
A
A
B
B