Workrite Sierra HX Crank Assembly Instructions for 2-Leg Crank models - Manual (Page 3)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3
Workrite Sierra HX™ 2-Leg Crank Workcenters - Assembly Instructions
Placement of the legs is very important. Take the time now to lay out the Legs (E), Leg Braces (B,
C, and F), Crank Tube (D), and Leg Caps (G) on the floor in the proper location.
Note that the right leg will be on your left and vice versa when the assembly is seen from the back.
b
1
...continued
2
Attach Leg Caps to Legs
If you have purchased the HX Spacer Accessory Kit, refer to instructions provided with that
product. Otherwise, proceed to step a.
To avoid stripping the threads,
always insert and make the
first few turns of the screw BY
HAND with an Allen wrench
(N), ensuring it is in straight.
Attach one Leg Cap (G) to the top of each Leg (E) using
Button Head Screws (H).
See drawing in Step 3 for correct orientation of legs.
a
3
Attach Long Brace to Left Leg
With legs on their sides, attach
Long Brace (B) to back of Left Leg
Cap using Button Head Screws (J).
The Brace should have the lip on
top, facing away from the leg. Do
not tighten screws completely
- allow them to slide left and
right in brace.
a
front
back
Left Leg
G
H
J
B
N
E
b
Right Leg Left Leg
G
E
F
C
B
D