Show? like others? 9 10, Ab a – Workrite Sierra HXL Assembly Instructions for 2-Leg Front Crank Workcenters User Manual
Page 7

Workrite Ergonomics | 800.959.9675 www.workriteergo.com
7 of 8
Workrite Sierra HXL™ 2-Leg Crank Workcenters - Assembly Instructions
Attach Front Crank Drive
The front crank drive and handle can be installed on the
right or left side as required. The steps shown illustrate
a right side handle installation (change to opposite side
for left installation).
Place the Crank Handle Assembly (E) into the Right Leg
as shown.
Attach with #12 × ½" Self Tapping Phillips Pan Head
Screw (K) and tighten firmly.
Attach the Handle Mount
For Workrite Tabletops:
Locate the pre-drill holes for the handle mount. Install
four #12 × ¾" Pan Head Wood Screws (M) and tighten
firmly. Go to Step
11
.
For Other Tabletops:
Measure 3½" back from the front of top to the front of
the handle mount. Be sure the handle is not at an angle.
Drill ⅛" × ¾" deep pilot holes. Take care not to drill
through top! Install four #12 × ¾" Pan Head Wood
Screws (M) and tighten firmly.
Confirm All Screws are Tightened and Flip Table Over
Tighten all screws in frame assembly and tighten all screws connecting frame to worksurface. Flip
table over and adjust Leveling Glides if required so that table is steady and does not rock.
Position Crank
Pull out and turn handle to raise or lower table. Push the
crank under the desktop for storage.
Note: Force required to turn the front crank handle may
be slightly higher for the first few sit-to-stand cycles.
This is normal operation and the force necessary will
decrease after initial use.
Adjust Leveling Guides
If necessary, adjust leveling guides on table feet to level the worksurface.
a
b
E
K
3½"
a
M
If you have a Silhouette
1/2-inch top, be sure
to use Pan Head Self-
Tapping Screws or you
will damage your top!
Show? like
others?
9
10
a
b
a
11
12
13
HANDLE UP AND OUT
HANDLE DOWN AND OUT
HANDLE UP AND IN
HANDLE DOWN AND IN