Workrite Sierra HXL Assembly Instructions for 2-Leg Front Crank Workcenters - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5 of 8
Workrite Sierra HXL™ 2-Leg Crank Workcenters - Assembly Instructions
Secure Long Bracket
Attach Long Bracket to back of right Leg Cap using M6 × 8 mm Button Head Screws (J). Do not
tighten screws completely - allow them to slide left and right in Bracket.
Attach Legs to Hex Shafts and Crank Tube
Turn Leg Assembly upside down.
Right Leg: Insert short end of Deep Hex Shaft (G) into leg. Slide Crank Tube (Q) over Deep Hex
Shaft.
Left Leg: Insert short end of Shallow Hex Shaft (F) into leg. Slide Crank Tube (Q) over Shallow Hex
Shaft.
Attach Feet to Leg Assembly
Attach Foot (R) to left leg with M6 ×16 mm Flat Head Machine
Screws screws (L) and tighten securely. Repeat for right foot.
Right Leg Left Leg
G
Q Q
F
J
5
a
b
a b
6
a
7
a
R
L
Right Leg
H