Workrite Sierra HXL Assembly Instructions for 2-Leg Front Crank Workcenters - Manual (Page 4)

4 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra HXL™ 2-Leg Crank Workcenters - Assembly Instructions
Attach Long Bracket to Left Leg
With legs on their sides, attach
Long Bracket (P) to back of Left
Leg Cap using M6 × 8 mm Button
Head Screws (J). The Bracket
should have the lip on top, facing
away from the leg.
Do not tighten screws
completely - allow them to slide
left and right in Bracket.
Attach Short and Medium Brackets to Leg Assembly
Attach both Short Brackets (B) using M6 × 8 mm Button Head Screws (J). Do not tighten screws
completely - allow them to slide left and right in Bracket.
Attach Medium Brackets (C) to sides of Legs using M6 × 8 mm Button Head Screws (H). If you
have a 24" deep or less worksurface, use the holes to the rear of the Bracket as shown. For deeper
worksurfaces, use the center holes of the Bracket as shown. Do not tighten screws completely -
allow them to slide left and right in Bracket.
a
back
Left Leg
4
30" deep
30" deep
B
3
a
b
J
H
P
C
J
J
C
J
B
J
H
J
C
C
J
24" deep
24" deep
holes
towards
back
holes in
center
holes in
center
holes
towards
back
b
b
a
Front