For service manual only – Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual User Manual

Page 52

设定远程感应器或恒温
器
Set up remote
sensor

or thermostat

10号设定项

Setting 10


使用模式按钮进入10号设定项。
 Press “Settings” button to advance to Setting 10.

使用向上或向下键调整设定。
 Press the “Up” or “Down” arrow buttons to

adjust to the desired setting.

远程感应器（Remote sensor）
Remote sensor

远程界面（Remote interface）
Remote interface

本地界面（Local interface）：只使用本穿墙

式系统
Local interface – WG25 only

平均（Averaging）：需事先调整跳线。请参

考第45页。
Averaging – Jumper position within sensors
must be adjusted. See page 45.

室内感应器标定
Room sensor
calibration

15号设定项

Setting 15

使用模式按钮进入15号设定项。

 Press “Settings” button to advance to Setting 15.

使用向上或向下键进行设定。最大值为+5，最

小值为-3，出厂默认值为0。感应器标定将对
温度读数产生影响。



 Press the “Up” or “Down” buttons to adjust to

the desired setpoint. Maximum setting is +5,
minimum setting is -3. Factory default is zero
(0). Sensor calibration setpoint changes the
actual display reading (temperature only) by
the value of this setting.

例如：感应器读数为2摄氏度

Example: Sensor reading = 2 Deg C

若将此处值设为+4

Setting 15 Set to +4

此时屏幕将显示14摄氏度

Display reading = 14 Deg C

FOR SERVICE MANUAL ONLY

This manual is related to the following products:

Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG15) - Manual