Wine Guardian Through-the-Wall Cooling System - Manual - Manual (Page 6)

6
Receiving, Inspecting and Unpacking the Wine
Guardian System
NOTE: Wine Guardian systems are factory assembled and tested prior to
shipment.
Wine Guardian systems are shipped individually in corrugated boxes specially designed to
protect the equipment during shipment.

 Before opening the container, inspect the packing crates or boxes for obvious signs
of damage or mishandling.
 Write any discrepancy or visual damage on the bill of lading before signing.
 Inspect all equipment for any sign of damage caused during transit.
 Report all visual or concealed damage to the carrier and file a claim immediately.
WARNING
* DO NOT LIFT THE UNIT UP FROM ITS PLASTIC FRONT PIECES
TO AVOID DAMAGING THEM
**THE UNIT SHOULD BE LIFTED FROM UNDERNEATH ITS BASE AT
BOTH ENDS OF THE SYSTEM.
Review the Packing Slip to Verify:
 Model number
 Factory-installed options
 System accessories
If any items listed on the packing slip do not match your order information, contact the place
of purchase immediately.
Check the unit for :
 An electrical power cord (factory installed on condenser side)
 The Easy Mount™ Through-the-Wall mounting sleeve.
 Accessories such as condenser air duct collar or duct collar kit, and optional controls, if
ordered.
 The EasyMount™ Through-the-Wall mounting sleeve.
IMPORTANT
If this procedure is not followed, the shipping company may reject the
claim and the consignee may suffer the loss. Do not return the shipment
to the factory.