Wine Guardian Through-the-Wall Cooling System - Manual - Manual (Page 28)

28
2. Remove the back plate of the controller
and mark the mounting points at the
desired location. (Fig. 2)
a) Mark the location of the
communication
cable connection as this area will
require
sufficient clearance for instance, a
1½” hole in the
wall for flush mounting of the back
plate. (Fig. 3)
3. Drill two 1/8” holes and insert anchors
(provided) within the mounting surface.
Anchors may not be required if securing to a
wall stud or racking system.
4. Plug in the communication cable to the
back of the Remote Interface Controller
backing plate. (Fig. 4)
a) Attach backing plate to wall using
the two screws provided with the
system. (Fig. 5)
5. Re-install plastic face plate on to backing
plate.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6