Wine Guardian Through-the-Wall Cooling System - Manual - Manual (Page 32)

32
Standard Controller Functions
How to:
Turn system on/off

Press the On/Off” button once.
NOTE: There is a five- second time
delay before the system turns on or turns
off.
Change Temperature

Press the “Up” arrow once. The display will
show the existing temperature setpoint
along with the “Mode” (Auto, Cool or
Heat).

Press the “Up” or “Down” arrow buttons to
adjust the temperature to the desired
setpoint.
Change Humidity

Press the “Up Arrow” once. This display
will show the existing temperature setpoint.

Press the “Mode” button once to display the
Humidity setpoint.

Press the “Up” or “Down” arrows to adjust
the humidity to the desired setpoint.
NOTE: a Wine Guardian humidifier
must be installed and setting six set to
“1” before the controller will display and
let you change percent humidity
.
Change Mode --
Cooling/Heating/Auto

Press the “Mode” button once to display the
“Set Mode” function. The existing mode
will display below the words “Set Mode.”

Press the “Mode” button again to scroll
through settings for “Cool” (cooling only),
“Heat” (heating only) or “Auto” (cool and
heat).
Settings – Press and hold the “Mode” button for five (5) seconds to access the following settings.
Humidity
Up Button
Down Button
Mode button
Alarm Indication
Area
Temperature
ON/OFF