Vinten Radamec Fusion Camera Control Unit (CCU) - Manual (Page 15)

4
7. At the prompt type “Y” then press the ENTER key. Proceed following the Hyper terminal prompts and
change the channel address as required. The Local IP address must be unique for each module:
Module-1 Local IP 198.9.200.221
Module-2 Local IP 198.9.200.222
Module-3 Local IP 198.9.200.223
Module-4 Local IP 198.9.200.224
Module-5 Local IP 198.9.200.225
Other addresses elements are common for all modules:
The Netmask:
255.255.255.0 for all modules
Default router: 198.9.200.1 for all modules
Local port: 1200 for all modules
Remote IP: 0.0.0.0 for all modules
Remote port: 0 for all modules
8. With the above changes made, check that the read-back is correct and type “n” and then press ENTER.
HyperTerminal should report “Starting the main application”. Check that the Channel LED on the front
panel of the Fusion CCU is not illuminated.
9. With the channel IP address now set, return the Configuration DIL switch for the channel to the up
position (OFF).
10. Reset the channel configured by pressing the reset switch accessible through the small hole in the rear
panel.
Repeat the process for setting the IP address for any other channel.
Figure 1 Hyper terminal window
Important Note: ALWAYS ensure that the Configuration DIL switches are switched OFF (in the up
position) on completion of any changes to the channel configurations.