Vinten Radamec Ci Box ICE Interface - Manual (Page 8)

6
Installation
Tools Required
Pozidriv PZ-1
screwdriver.
Potentiometer adjuster
or small flat blade
screwdriver.
Mounting the Ci Box
The Ci box is supplied with four rubber feet which can be fitted to the
base so that it can be placed on any level surface. However, the Ci box
can also be attached to equipment in an installation using one of the
following mounting kits:
Fitting the Rubber Feet
1. Peel the self adhesive backing
from the rubber foot.
2. Press the rubber foot firmly into place in one of the mounting point
recesses on the base of the Ci box. Fit the other three rubber feet
using the same procedure.
Mounting Kit Part No. Use
Ci box fixing
kit V4115-1901
(Included) To mount the Ci-box onto studio
equipment such as a tripod leg
Ci box Rack
shelf kit
V4115-1900
To permanently install the Ci-
box in a 19-inch rack
OR
Note
The supplied rubber feet should always be fitted to the
base of the Ci box unless it is to be mounted using the rack
shelf kit.