Vinten Radamec Ci Box ICE Interface - Manual (Page 16)

14
Troubleshooting
Fault Check Comments
The Ci box is not
powering up. Check that the AC adaptor is connected and secured.
See the section Rear Panel Data
Connections on page 11 If the Ci box is being powered by a battery pack, ensure that the battery
is fully charged.
Check that AC power is being supplied to the AC adaptor.
Intermittent or no
communication
with connected
camera equipment. Check that the camera equipment is receiving power and is switched on.
Check that any data cables between the Ci box and the camera
equipment are correctly connected and secured. See the section Fit the supplied cable clips
to the back edge of the rack mount shelf
to secure any connecting cables used in
the installation. on page 10
If long modem cable runs are being used, try boosting the signal level
supplied from the Ci-1.
See the section Data Indication on page 12
Check that the modem baud rate is set correctly for the current
installation. See the section Changing the Data Baud
Rate (Ci-1 Only) on page 12