Vintage Cellars Wine Guardian Water-Cooled Cooling System - Manual (Page 26)

23
Installing the Unit Outdoors
The Wine Guardian is NOT designed nor approved for direct outdoor installation. If it is located
outdoors, it MUST be protected with a rain-proofed enclosure.
• Mount it above the ground on a solid, waterproof base to protect the unit from ground
water.
• Do not locate it where grass clippings or leaves can blow into the unit.
• Keep the area around the unit clean and free of debris.
• Protect from damage when the unit is located in a garage or unheated shed. In both cases,
the unit MUST have the low ambient controls built into the unit.
• Double insulating ducts with exterior grade insulation is recommended to keep the ducts dry
and effective. Wine Guardian suggests installing one sized flexible duct inside the next
larger size duct where ductwork is exposed.
• Allow enough space at both ends of the unit to remove the grilles or ductwork and allow
access to the filters.
Mounting the Unit
CAUTION
RISK OF PERSONAL INJURY OR DAMAGE TO EQUIPMENT
Check supporting structure for load bearing capacity to support the Wine Guardian.
All supports must be designed to meet applicable local codes and ordinances.
If in doubt, consult a qualified architect, engineer or contractor.
Note
Review the mounting illustrations on pages 32 and 33 before mounting the unit.
Floor Mounting
Mount the Wine Guardian on the floor but elevate it on frame with a plywood surface to keep it away
from water. Allow adequate space for the external drain.
Wall Mounting
If the unit is mounted through the wall, adequately support it on both sides of the wall. Use floor or
knee braces to transfer the load of the unit to the floor or wall.