Vintage Cellars LECBILD1400 - Manual (Page 19)

B I L D W I N E C A B I N E T S
-19-
Minimum Set Point of 58°F and a
Temperature Differential of 4°F. This means
that the cooling unit will turn on when the
display rises above 62°F (58°F + 4°F), and turn
off when the display falls below 58°F.
To view the Minimum Set Point, press the
“Set” button for one second.
To change the Minimum Set Point:
1. Press the “Set” button for three
seconds until “°F” blinks
2. Press the “Up” or “Down” button
3. Press the “Set” button to confirm
The “Set” temperature will blink three times to
indicate confirmation.
The recommended Minimum Set Point range
is 53 - 60°F. To change the Temperature
Differential, see “Advanced Operation” later
in this chapter.
Energy Saver Button To activate and deactivate the “Energy
Saver” mode, press the “Energy Saver”
button
The “Energy Saver” indicator light will turn on
when the cooling unit is in “Energy Saver”
mode
In “Energy Saver” mode, the Minimum Set
Point increases 4°F and the Temperature
Differential is unchanged
Quick Chill Button To activate the “Quick Chill” mode, press the
“Up” / “Quick Chill” button for three seconds.
To deactivate “Quick Chill”, press “Quick
Chill” button for three seconds again
The “Quick Chill” indicator light will turn on
when the unit is in “Quick Chill” mode.
In the “Quick Chill” mode, the unit will run
continuously for 6 hours (or until the intake
temperature registers 50°F). This mode is
useful after loading “warm” bottles in a cellar