Vintage Cellars Transtherm Bastide Glass Door Wine Cellar Black - Manual (Page 9)

GB
English - P 9
2 • Temperature settings
Description du tableau de commande
• Temperature display: displays the actual temperature inside your wine
cabinet. It is therefore
necessary to wait before your new setting takes effect.
• Simply press and hold down SET for a few seconds to see the tempe-
rature setting.
• Buttons ( / / SET): allow you to select the desired temperature inside
the cabinet.
• Standby button ( ): allows you to activate the cabinet and put it on
standby.
3 • Commissioning the control panel
By default, the control is in the on position. To put the cabinet on standby,
push and hold down the button ( ) for several seconds.
The display switches between the internal temperature and the OFF
display (the cabinet is no longer operating, only the display is active).
To reactivate the cabinet, press and hold down the button ( ) for several
seconds until just the temperature is displayed.
4 • To set the temperature of your wine cabinet
The temperature of your wine cabinet is set entirely from the control panel.
Press and hold down the SET button for a few seconds until the tempera-
ture setting flashes.
• Set the desired temperature using the and buttons.
• Confirm your programming by pressing the SET button. If you do not
confirm your setting with this key, your modification will not be registered.
5 • Status lights:
Compressor 1: indicates that the compressor is operating. When this
flashes, it means that the compressor is going to start up in a few minutes
(technical delay).
Defrosting cycle 2: indicates that an automatic defrosting cycle is underway.
Heater 3: indicates that the heater is operating.
Alarm 4: informs you that there is an abnormally high or low temperature
1
2
3
4