Vintage Cellars Transtherm Bastide Glass Door Wine Cellar Black - Manual (Page 8)

P 8
Commissioning and Temperatures settings
1 • Commissioning
- Once you have waited 48 hours, connect your cabinet to the
mains, having checked that there is power to the socket (check fuses and
their amperage, the state of the trip, and if necessary try out another
electrical appliance to verify the supply).
- Once connected to the mains, make sure that the Off/On switch, on
the right of your cabinet’s control panel, is set at "On" (I).
You should remember that if you do not have enough bottles to fill
your wine cabinet, it is better to distribute the load over all of the
shelves available, so as to avoid "all on top" or "all below" type loads.
ecommandation
important
stuce
Trick
ecommendation
The shelves all have a label slot, designed to receive the pre-cut cards
delivered with your cabinet, thus helping you to identify the position
of your favourite wines at a glance.
ecommandation
important
stuce
Trick
ecommendation
Rearrange the locking pins when changing from sliding shelf to storage or
presentation shelf.
- A sliding shelf can only hold one layer of bottles (maximum of 13
"Tradition" Bordeaux bottles).
- In order to enjoy optimum accessibility when setting up the cabinet in a
mixed layout, we recommend that shelves destined to be used as sliding
shelves are located in the middle section of the cabinet.
NEVER SLIDE MORE THAN ONE SHELF.
On/Off button