Vintage Cellars Transtherm Bastide Glass Door Wine Cellar Black - Manual (Page 6)

P 6
Layout and loading recommendations
All shelves can be used as storage, sliding or presentation shelves. Your
cabinet’s shelves have 13 recesses allowing you to store your bottles in
complete safety.
Storage rack
To install bottles on a storage shelf:
- Insert the shelf at the desired position.
- Place a wooden locking pin in each of the 2 holes located on the right
and left side of the upper face approximately 15 cm to the front of the shelf
(see diagram): these pins secure the shelf to the thermoformed wall and
prevent any inappropriate movement.
ecommandation
important
stuce
Trick
ecommendation
Installing the handle
Installing the handle of your wine cabinet is carried out in the following
manner:
- Introduce the two spacers (B) into the
holes on the inside panel of the door.
- Add the two washers (C)
- Using a screwdriver, secure the handle
(A) with the two screws (D).
- Clip the two knobs (E) onto the washers.
As a security
measure, the lock
works on a
double movement
system. The key
should be pushed
inward and
turned at the
same time.
In order for you to level off your cabinet as easily as possible, it is
equipped with 4 adjustable feet. However, we do recommend that
you tighten the back feet to the maximum and use the front feet
to create a level (a spirit level is recommended for this operation).
WAIT 48 HOURS BEFORE PLUGGING IN THE CABINET
Should you need to move your cabinet, never tilt it more than 45° and
always sideways, on the side that the electrical cable comes out (right
hand side when looking at the cabinet).