Tycon Power RPST2424-100-280 - Manual (Page 2)

2
Qwik Install
STEP 1: Add Grounding Wire Between Door and Enclosure: Remove
plastic covers on copper studs
on inside of door and inside of
enclosure. Add jumper wire be-
tween 2 copper studs and use
copper washers and nuts to se-
cure.
STEP 2: Add wire feedthrus and
any necessary connectors into
the bottom connector plate. Attach the
connector plate to the bottom of the
enclosure using self tapping screws
provided.
STEP 3: Install hole plug in drain
hole in bottom right corner of the en-
closure.
STEP 4: Mount the DIN rail to the
door using screws provid-
ed. Mount any extra
equipment to the orange
backplate and secure the
backplate in the enclo-
sure. Note: The DIN rail
can also be mounted to
the orange backplate or
sides of enclosure if de-
sired.