Tycon Power TP-SCPOE-12XX Series - Manual (Page 3)

User’s Manual TP-SCPOE-12XX Series
Panel Description:
Item Name Descriptions
1 POE :
PoE power input indicator: the LED lights when the PoE input jack
(the lower jack) has 18V~57V input.
2 SOL :
Solar power input indicator: the LED lights when SOL terminal is
connecting to a solar panel and the solar panel input voltage is over
12V.
3 CHA :
Charging indicator: the LED lights when BAT terminal is connected
to battery and charging
4 LOA :
Loading indicator: the LED lights when the rear panel output
terminal is connecting to a device and offering power.
The LED always on when power ready.
5 REV :
Battery polarity reverse indicator: the LED lights when the battery
polarities are reversed. (detail description see Sec. 5.1
6 IN :
PoE Input Jack: the lower RJ45 jack, used for PoE input. Allowed
input voltage 18~57V
7 OUT :
PoE Output Jack: the upper RJ45 jack, used for PoE output; Output
voltage depends on what model you selected.
8 Fuse
Fuse: for output over current protection, limiting the battery output
current <= 10A. (If solar panel or PoE source is installed before the
battery, and if the polarities of battery are reversed, then the fuse will
be burnt.)
9 SOL : Solar Panel Terminal: used to connect the solar panel.
10 BAT :
Battery terminal: used to connect the battery.
NOTE: ALWAYS CONNECT THIS TERMINAL FIRST AND
DISCONNECT LAST.
11 LOA :
Load Terminal: The output voltage is the same as battery voltage.
Maximum voltage clamped at 12.5V.