Fault_msg_invalid_freq_received (104h), Cause, Solution – ThingMagic M6e User Manual
Page 67: Fault_msg_invalid_parameter_value - (105h), Fault_msg_power_too_low - (106h), Fault_unimplemented_feature - (109h), Fault_msg_invalid_freq_received (104h) 67, Fault_msg_invalid_parameter_value - (105h) 67, Fault_msg_power_too_low - (106h) 67, Fault_unimplemented_feature - (109h) 67
Common Error Messages
Appendix A: Error Messages
67
FAULT_MSG_INVALID_FREQ_RECEIVED (104h)
Cause
A message was received by the reader to set the frequency outside the supported range
Solution
Make sure the host does not set the frequency outside this range or any other locally
supported ranges.
FAULT_MSG_INVALID_PARAMETER_VALUE - (105h)
Cause
The reader received a valid command with an unsupported or invalid value within this
command.
For example, currently the module supports four antennas. If the module receives a
message with an antenna value other than 1 to 4, it returns this error.
Solution
Make sure the host sets all the values in a command according to the values published in
this document.
FAULT_MSG_POWER_TOO_LOW - (106h)
Cause
A message was received to set the read or write power to a level that is lower than the
current HW supports.
Solution
Check the HW specifications for the supported powers and insure that level is not
exceeded. The M6e supports powers between 5 and 31.5 dBm.
FAULT_UNIMPLEMENTED_FEATURE - (109h)
Cause
Attempting to invoke a command not supported on this firmware or hardware.