ThingMagic M6e - Manual (Page 33)

Assembly Information
A D I V I S I O N O F T R I M B L E
Hardware Overview 33
Assembly Information
Cables and Connectors
The following are the cables and connectors used in the M6e Developerʼs Kit interface
board:
Digital Interface
The cable assembly used consists of the following parts:
 2 Connector Shells [Molex 51021-1500] with 15 Crimp Contacts each [Molex 50079-
8100]
 1 Wire (#28 AWG 7x36 - Black, Teflon) for Pin 1 connection [Alpha 284/7-2]
 14 Wires (#28 AWG 7x36 - White, Teflon) for other connections [Alpha 284/7-1]
Note
Pin numbers and assignments are shown in the M6e Digital Connector Signal
Definition table.
Antennas
The cable assembly used to connect the “external” RP-TNC connectors on the M6e
Devkit to the M6e MMCX connectors consists of the following parts:
 1 Reverse TNC Bulkhead Jack Connector
 1 LMR-100A Coaxial Cable
 1 MMCX Right Angle Plug Connector