Smart Power Systems HR-30 (3-Phase) - Manual (Page 51)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 50 of 52
3.
Disable the generator Pump Set option.
After the pump has been properly adjusted, disable the Pump Set option by performing
the following steps:
Step a: Hold Mode until
Amps Line 1 Blinks
88.
Release switch so 0Pt
appears.
Step b: Press mode twice
to make PSEt appear.
Step c: After selecting
PSEt, Press On/Off until
n appears.
Disabling pump set option
Figure 31
a. Press and hold the Mode switch until the Amps Line 1 field blinks with 88 (more
than 10 seconds). Release the switch while the Amps Line 1 field is blinking to
make
0Pt appear. Reference Figure 31.
b. Press the Mode switch until
PSEt appears.
c. Press the On/Off switch until an
n appears, indicating Pump Set option is
inactive.
d. Put system into Normal mode by pressing the Mode switch.