Smart Power Systems HR-110 User Manual
Page 38
Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 37 of 53
WARNING:
Do not by-pass the filter or alter filtration plumbing in any way. Doing so will void
the system’s warranty.
3.
The system controller automatically records the time from the previous filter change.
The hours since the previous filter change can be accessed using the Command &
Control Center by pressing the Mode switch until the following screen appears
(reference Figure 25):
Time Since last Oil Filter
Change in Hours.
Press Mode until
and are displayed
Example of oil filter run time display
Figure 25
4.
The Command & Control Center will flash a fault when 250 hours have passed
since the previous filter change. After replacing the filter, this fault can be removed
from the Command & Control Center, and the filter run time can be reset by
performing the following steps: