SINGER SEQS-6000 FUTURA QUARTET Instruction Manual - Manual (Page 21)

19
ZIGZAG STITCHING
The top thread may appear on the bottom depending on the
thread, fabric, type of stitch and sewing speed, but the bobbin
thread must never appear on the top of the fabric.
SETTINGS :Presser foot - General Purpose Foot
:Thread tension control - S
is values set automatically when pattern (No. 03) is set.
The stitch length is 2 mm and the stitch width is about 5 mm.
is the selection range when setting the value manually.
ADJUSTING STITCH WIDTH AND LENGTH
PLACEMENT OF PATTERNS
Stitch width of pattern increases from center needle position
as illustrated.
SATIN STITCH
This is a closely spaced stitch used for appliqué, bar-tacking,
etc. Slightly loosen the top thread tension for satin stitching.
Set the stitch length between 0.5 and 2.0, depending on the
weight of thread being used.
Use a backing of stabilizer to help avoid stitches puckering the
fabric.
Under side
Top side
STITCH WIDTH
STITCH LENGTH
Center position
mm 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0 6.5 7.0
0
0.3
0.5
0.8
1.0
1.3
1.5
1.8
2.0
2.5
3.0