Origin Live Power Supply Upgrade - Manual (Page 5)

Photograph showing the wires after soldering
in place.
Close up of soldered joints.
9.
Using the supplied tie, secure the wires at this
point. Also ensure that the DC leads going to the
terninal block are pushed down clear of the
revolving platter.
10.
Replace the platter and platter mat. It is better
not to replace the internal cover as this can induce
microvibrations and audibly degrade the sound.
Plug the Origin Live wall wart (or upgrade
transformer) into a mains socket and connect it to
the power supply (box with LED). Then connect
the DC lead from the turntable into the power
supply.
Power up the deck and ensure that you have
rotation of the platter. Press stop and take note of
the stopping motion. If it stops perfectly without
reversing or slowly spinning then you may skip
steps 11 and 12.
11.
As the turntable has a new supply the
electronic brake must be calibrated accordingly.
Disconnect the power from the turntable and
remove the platter and platter mat to get access to
the circuitboard. Locate the adjustment
potentiometer as shown in the image.
It will be labeled “BRAKE”.
Power in To turntable