Origin Live Building a turntable almost from scratch - Manual (Page 7)

7
Parts list & tools required
Parts supplied
Standard kit of parts
Platter & Sub-platter
Main bearing house bottom nut & ¾” UNF top nut + bearing house plate (fitted on complete standard kit)
Standard Motor & fitted short pulley - 3 off M2 x 6mm motor screws in bag, 2mm A/F Allen key
Power supply 230 volt or 110 volt (delete one)
Standard DC regulator board / switch
Bearing house plate, rectangular motor plate, Oil, STANDARD BAG OF PARTS – Belt, 2 off cable clips, 10 off No 6
x ¾” screws, 3 off no6 x ½”, 4 off M5 brass washers, Optional Parts
Complete Standard kit (added to kit of parts)
Standard Plinth, 3 off large rubber feet + 3 screws & washers + bearing house plate & armboard
Lid, 2 off Lid hinges, 4 off M4 screw & M4 nuts
Optional parts
Ultra plinth, 4 off small rubber feet & 4 nails
Sub-chassis ( MDF damper arm & spring plates, glued washers)
Spring kit Bag - 3 springs / 3 long M5 bolts / 3 spring seats / 3 rubber washers / 6 off M5 brass washers / 9 off M5
serrated washers / 6 off M5 nuts
Advanced DC regulator board / switch
Upgrade Transformer
Sliding VTA adjuster, Aluminium sleeve, M6 x 16 allen set screw, 3mm A/F Allen key
Threaded VTA adjuster and packing washer
Arm (optional)
Paperwork
Turntable instructions
Strobe card
Upgrade transformer sheet (optional)
Tools you will need ideally
Ruler or measuring tape & Marker pen.
Small hacksaw or powerful snips
Cross head screwdriver
3mm or 3.5mm drill
Pliers or molegrips
Hammer
Soldering iron (not essential)
Spirit level