Origin Live Calypso & Resolution - fitting the 12 inch sub-chassis and all other subchassis - Manual

Plinth
Pivot bolt – cap head
On TOP
Inertia disc
Pivot Spacer
Pivot nut hidden
From view UNDER
plinth
Anti-rotate stud - do not
Adjust or remove
Assembly of deck sub-chassis to plinth
Read carefully or damage can occur
Please fit the Subchassis to the plinth following the instructions on these sheets. This part
is not pre-assembled to prevent potential distortion that can occur in transit if it is rigidly
attached to the plinth.
Preliminary notes The subchassis is carefully built such that the platter is parallel to the
armboard. Do not tamper with any of the bolts on the sub-chassis even if they may not
appear to be seriously tight.
On the Resolution and Sovereign decks - When you finally level the deck, note that the
acrylic part of the armboard is not a reference surface – only the chrome inner disc is true
to the platter level.
Turntable as packed / on arrival
The deck arrives as shown above. First, undo the
Pivot nut using the spanner provided whilst holding
the bolt head on top with the Allen key. It is easiest to
rest the deck on it's side (see photo alongside) whilst
you carry out this operation.
Once the nut is removed, do not allow everything to fall
apart. Hold the pivot bolt in, and keep the inertia disc
pressed onto the plinth. Also check that the anti-rotate
stud in the underside of the inertia disc remains in its
restraining hole in the plinth (see illustration overleaf)