Origin Live Aurora - fitting the 12 inch sub-chassis and all other subchassis User Manual
Assembly of deck sub-chassis to aurora plinth, Turntable as packed / on arrival
Plinth
Pivot bolt – cap head
On TOP
Damping disc with
Cork ring on underside
Pivot Spacer
Pivot nut hidden
From view UNDER
plinth
Anti-rotate stud - do not
Adjust or remove
Assembly of deck sub-chassis to Aurora plinth
Read carefully or damage can occur
Please fit the Subchassis (single or dual armboard) to the plinth following the instructions
on these sheets. This part is not pre-assembled to prevent potential distortion that can
occur in transit if it is rigidly attached to the plinth.
Preliminary notes Do not tamper with any of the bolts on the sub-chassis even if they
may not appear to be seriously tight. In the case of the dual armboards the armboards have
been levelled using bolt tensions.
Turntable as packed / on arrival
The deck arrives as shown above. First, undo the
Pivot nut using the spanner provided whilst holding
the bolt head on top with the Allen key. It is easiest to
rest the deck on it's side (see photo alongside) whilst
you carry out this operation.
Once the nut is removed, Make a mental note of the
parts and their positions before withdrawing the bolt.