Oldcastle BuildingEnvelope Thermal Clad Door and Frame - Manual (Page 27)

ATTACHMENT OF AND ADJUSTMENTS TO HARDWARE
D O O R A N D F R A M E
CLOSER
Refer to instructions that are sent in the boxes for installation of the following items, unless noted otherwise:
Surface
Norton 1600 Series
LCN 4040 Series
LCN Quest — Peel-off templates and instructions are sent in box.
Concealed
Jackson 20-330
LCN 2030
Dorma RTS-88
Floor
Rixson 27 (Offset Hung)
Rixson 28 (Center Hung)
Dorma BTS-80
EXIT DEVICE (PANIC) — Rim
(RP-100)
EXIT DEVICES — Concealed Rod
(CP-100)
(VIP-1) Installed in door at factory
(VIP-2)
DOOR SWEEP
V-231
Cut to length for door.
Apply 2-sided tape to back of part.
Peel protective sheet off.
Place in position at bottom of door.
Drill pilot holes through holes in V-231 into door.
Fasten with screws supplied.
27 MAY 2012
D O O R & F R A M E I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)