Oldcastle BuildingEnvelope Reliance FRP - Manual (Page 8)

7 


R E L I A N C E C U R T A I N W A L L I N S T A L L A T I O N M A N U A L
2.7 Pressure plate reinforcement AW-310 must be installed at each horizontal to vertical intersection for deep face
caps as noted in 2.8. Reinforcement will be held in place with FS-325 pressure plate fastener. Face cap, pressure
plate and reinforcement will be fabricated with .156" hole on each side at center of face cap. A FS-303 , 5/32" x 3/4" lg
dowel pin (part# xxx) must be inserted at each side of face cap to secure the cap to the reinforcement. See FIGURE 6.
2.8 Use AW-310 reinforcement at all face caps deeper than 1-1/2" with maximum cap depth of 4".
FIGURE 6
Deep Face Cap Installation
AW-162
FS-325
AW-310-01
FS-304
PARTS LIST
PRESSURE PLATE FABRICATION
FS-325
MAX. 4"
FS-304 Spring pin
AW-310-01
AW-162
Drill 5/32" (.156Ø)
Hole in reinforcement
and pressure plate
FRP PRESSURE PLATE
FRP Pressure Plate
Deep Cap
Reinforcement
Spring Pin
for AW-310-01
#12-24 X 1-1/2
HWH Drill Flex
(Typ. Pressure Plate)
™