Old Town ACS Seat Replacement Kit - Manual (Page 2)

Rev. Orig
Issue Date: 1/14/2010
Doc. # K-07.1982.0000
Johnson Outdoors
125 Gilman Falls Rd Building B
Old Town, Maine 04468
1-800-8-KAYAKS
http://www.neckykayaks.com
ACS Seat
Replacement Kit
Page 2 of 4
3. Thread bolt through hole in seat strap making sure strap is untwisted. See Fig. #3. Screw Bolt into bow
hole of a Deck Bracket (G) ensuring the little loop on the bracket faces to the outside of the boat. Make
sure strap comes out between bow and stern hole of Deck Bracket. See Fig. #4. Repeat on the other
side of seat.
Fig. #3 Fig. #4
4. Use another Truss Bolt and Washer and attach bracket through Stern hole. Repeat on the other side.
5. Insert the tabs of the seat into the brackets making sure that the seat rests on the hull floor and is not
elevated. You must use the same rung of the bracket on each side of the seat. See Fig. #5
Fig. #5
6. With a 1/4” bit drill a hole in the center - Stern end of the cockpit rim. See Fig. #6. Tie an overhand
knot in the 9” Bungee (H) and run it down through the hole in the seat bracket then up and over the
bracket on the back of the seat. Then run it down through the hole at the back of the cockpit and tie a
double overhand knot. See Fig. #7
Fig. #6 Fig. #7