Cisco 3515 MCU24 - Manual (Page 23)

2-11
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
OL-17012-01
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
How to Perform the Video Processing Module Initial Configuration
Pointing the EMP to the Controlling Cisco Unified
Videoconferencing 3515 MCU
You can use the serial port to point the EMP to the IP address of the controlling Cisco Unified
Videoconferencing 3515 MCU unit.
Procedure
Step 1 At the prompt, enter M to change the Cisco Unified Videoconferencing 3515 MCU IP address and press
Enter.
The Cisco Unified Videoconferencing 3515 MCU IP address screen displays as follows:
Enter MCU ip address
Without leading zeros :
Step 2 Enter the IP address of the Cisco Unified Videoconferencing 3515 MCU and press any key to return to
the EMP Main menu.
Changing Advanced Configuration Settings
You can use the serial port to change these advanced configuration settings:
• Web server port (for future use)
• Restore factory configuration (for future use)
• LAN port settings
• Disable DSP reset
Procedure
Step 1 At the prompt, enter A to access the Advanced Configuration menu.
The Advanced Configuration menu appears as follows:
Advanced configuration menu
Q: Quit
1: Configure web server port
2: Restore factory configuration
3: Change Lan port Settings
4: Disable DSP reset
Select:
Step 2 At the prompt, enter 1 to configure the web server port.
The current web port server setting displays.
Step 3 At the prompt, enter 2 to restore the factory configuration settings.
You are asked to confirm your choice as follows:
Select: 2
Are you sure you want to restore factory configuration? [y, n]:
Step 4 Enter y or n.
Step 5 At the prompt, enter 3 to change Ethernet speed and duplex parameters.