Mercedes-Benz CLK-Class 2007 Owners Manual User Manual

Page 296

295

Controls in detail

Useful features

gins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.

If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.

Step 3:

Hold the end of hand-held remote
control

5 of the device you wish to

train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (

2, 3 or 4) to be pro-

grammed, while keeping indicator
lamp

1 in view.

Step 4:

Using both hands, simultaneously
press hand-held remote control
button

6 and the desired signal trans-

mitter button (

2, 3 or 4). Do not

release the buttons until step 5 is com-
pleted.

Indicator lamp

1 will flash, first slowly

and then rapidly.

Step 5:

After indicator lamp

1 changes from a

slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.

Step 6:

Press and hold the just-trained signal
transmitter button (

2, 3 or 4) and

observe indicator lamp

If indicator lamp

1 stays on

constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (

2, 3 or 4) is pressed and re-

leased.

Step 7:

To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.

Indicator lamp

1 flashes immediately the

first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.

If indicator lamp

1 flashes rapidly for about

2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.