Mercedes-Benz S-Class 2007 User Manual
Page 153
152
Control systems
COMAND navigation (introduction)
Display options with geo-coordinate dis-
play switched on
If the crosshair is displayed on the map
view (map was moved manually), only dis-
play
3 is visible.
It shows either the coordinates of the
crosshair or other data on the crosshair
position, e.g. a street name. The digital
map must contain relevant data in order
for this other data to be displayed.
Switching the geo-coordinate display on
or off
̈
Select “Navi”
Ǟ “Navi” Ǟ “Map Dis-
play”.
The map display list appears.
̈
Select “Coordinates”.
The geo-coordinate display is switched
on or off, depending on the previous
status. A checkmark indicates which
status is active.
̈
Exiting menu: Slide
o
m
p
or press
back button
L in the center console
Setting route mode
̈
Select “Navi”
Ǟ “Navi” Ǟ “Mode”.
The mode list appears.
̈
Switching mode on or off:
Select desired modes.
Depending on the previous status, the
mode is switched on or off. A check-
mark indicates that the mode is
switched on. It is possible to switch on
more than one mode.
̈
Exiting menu: Slide
o
m
p
or press
back button
L in the center console
COMAND will verify whether it can in-
corporate the modes if you select them
with route guidance active.
If it can, COMAND calculates a new
route while incorporating the modes
selected.
If it cannot, you will see and hear a cor-
responding message.
̈
Select “OK”.
COMAND calculates a new route.
Only those modes which can be in-
corporated are used.
i
There must be sufficient GPS reception for
displays
1, 2 and 3 to be shown. Height dis-
play
1 is an approximation because the naviga-
tion system uses the GPS signals for the
calculation.
i
If there is no crosshair on the map view, dis-
plays
1, 2 and 3 are visible. Display 3
shows the coordinates of the current vehicle po-
sition.
i
This function allows you to set the following
options for route guidance:
ț
“Minimize Highways”
ț
“Minimize Toll Roads”
ț
“Minimize Tunnels”
ț
“Minimize Ferries/Motorail”