Losi LOSB0235 Getting Started User Manual
Getting started
Getting Started
1.
Your Losi Micro Raminator includes 2 complete sets
of batteries. The Heavy Duty non-alkaline batteries
are to be used in the transmitter.
2.
Remove the battery cover by sliding it in
the direction noted on the cover. Install (8)
AA alkaline batteries into the bottom of the
charger. Pay close attention to the correct
direction of the positive (+) and negative(-)
ends as marked. Reinstall the battery cover.
3.
Plug the battery lead into the charger lead. The
RED LED will light up and stay solid while charging.
When the battery is fully charged the light will shut
off (approximately 20 minutes). If the charger light
only lights up for about a minute, the AA batteries
inside the charger are low and should be replaced.
4.
Remove the transmitter battery cover by sliding
it in the direction noted on the cover. Install eight
(8) AA batteries into the battery holder. Pay close
attention to the correct direction of the positive (+)
and negative (-) ends as marked. Once all 8 batteries
have been installed, reinstall the battery cover.
5.
Plug in the battery lead into the speed controller
lead and replace the body. Secure the body with the
included body clips.
6.
ALWAYS turn on the transmitter first by sliding the
switch “ON”. The small red and green lights above
the switch should both light up. If not, please check
for low or incorrectly installed batteries.
7.
Once the transmitter has been turned on, turn on the Losi Micro Raminator by sliding the switch to the “On”
position (located on the bottom of the chassis). If the rear wheels turn, adjust the “TH. Trim” knob located to the
lower right of the steering wheel until they stop. To go forward pull the trigger back. If you should need reverse,
wait for the model to stop then push the trigger forward. When going forward the model should move in a
straight line. If not, adjust the “ST.Trim” so that it tracks in a straight line without having to turn the steering wheel.
After you are finished running, turn the Losi Micro Raminator off FIRST by sliding the switch to the “Off” position.
After the model has been turned off, turn off the transmitter.
Charger