Losi LOSB0102 User Manual
Page 4
TM
Supplied tools:
2-Way wrench
Transmitter / Receiver BIND Plug
Four (4) Hex Wrench “L” shaped
.050, 1/16, 5/64, and 3/32
Flat Turnbuckle Wrench
Recommended Accessories:
-
Hobby grade knife
-
CA glue (LOSA7880 or LOSA7881)
-
Needle nose pliers
-
Side cutting pliers
-
Double sided tape (LOSA4004)
-
Safety Goggles
-
Soldering iron
Required Equipment:
Four (4) AA alkaline batteries for the transmitter.
A Six (6) cell NiMH battery pack. Or with proper
knowledge, LiPo battery packs.
NiMH battery charger with automatic “peak detection”
recommended.
Using your charger:
If you do not yet have a charger a peak-detecting charger
will provide the performance required and take care of your
expensive batteries.
A popular choice for a charger would be a peak detection
charger that can be plugged into a household A/C wall socket.
The peak detection portion of the charger monitors the battery
charging and will automatically shut off upon full charge.
The other choice of peak detection charger requires a 12V
power source to charge your batteries. You would need to use
or purchase a hobby grade 12V power supply before charging.
Transmitter Batteries
Vehicle Battery
(6-Cell 7.2V “Stick Pack”)
LOSB9900
DYN4044 Vision Peak 2 AC/DC Charger
Supplied and Required Equipment