Losi LOSB0018 Getting Started Guide - Manual (Page 3)

Page 3
Fueling
Fill your fuel bottle with fuel and lift the lid of the fuel
tank and fill the tank. Make sure to put the lid back on
both the fuel bottle and fuel jug.
Insert the Spin-Starter into the back plate of the engine and plug the exhaust with a rag.
Press the Spin-Start button and turn over the engine for 5 seconds to help prime the
engine. Excessive priming will flood the engine and make it difficult to start.
Install Battery
Start your Engine
Attach the glow plug igniter to the glow plug. If you are using an aftermarket glow
igniter with a meter make sure the needle is in the green or good condition.
Holding the starter securely, press on the switch button and the engine should
turn over and start.
If the engine does not turn over, it may be flooded or the battery in the starter
needs to be charged. Use the 4-way wrench supplied to loosen the glow plug at
least two turns and press the Spin-Start button again. Raw fuel should come out
around the glow plug. Tighten the glow plug and resume the starting procedure.
Follow the engine break-in procedure, found in the Operations Guide, before
attempting any racing or high performance operation. Use caution when adding
fuel while the engine is running. Do not over fill or spill fuel outside the tank.
Remove the cover from the Glow plug igniter.
Install a "C" size Alkaline battery with the "+"
end of the battery as shown.
Priming your Engine
“C”
Siz
e
+ Pos
- Neg