La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 4)

-- To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
1. Install the back.
• Lay the back across the ar ms of the body. Lift the back at a slight angle
and align the brackets on the back with the brackets on the body (F IGURE 1).
• Lower the back onto the body, making sure the back and body brackets
are completely engaged.
• To make sure the back is proper ly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F I G U R E 2). Remove the back and repeat the steps a bove.
• If you are una ble to install the back proper ly contact your La-Z-Boy ®
dealer for assistance.
• Lock the brackets by using a screwdr iver to push down the locking lever s
(F I G U R E 3).
- To reduce the risk of serious injur y:
• Check the condition of the power transfor mer s , electr ical cords , plugs
and connector s monthly. Keep the power transfor mer and electr ical
cords away from heat sources. Never operate the unit with a damaged
power transfor mer, electr ical cord, plug or connector. Contact your
La-Z-Boy ® dealer for ser vice.
NOTICE:
Do not plug the transformer in until instructed.
2. Locate and connect the Power Transfor mer.
• Locate the Power Transfor mer secured to the rear rail. Carefully cut the
ca ble tie and remove the Power Transfor mer from the rear rail. Remove
the packing and unwind the cord.
• Locate the Motor Extension Wire attached to the rear of the motor
(F I G U R E 4). Carefully cut the ca ble tie and unwind the cord.
• Align the white dot on the Power Transfor mer connector with the arrow
on the Motor Extension connector (F I G U R E 5). Push the connectors together
until they are secured, with no ga ps between them.
3. Attach the outside back upholster y cover.
• Pull the outside back upholster y cover down tight. Fir mly press the
fastening ta pe on the outside back upholster y cover to the fastening
ta pe on the bottom of the rear rail.
- To reduce the risk of serious injur y:
• Provide a clear path for operation of the chair, back and legrest.
Place ta bles and area r ugs at a distance to allow the legrest to fully
extend without r ubbing or interference.
4. Choose a location for the chair that is close to an electr ical outlet and
proceed to the Operating Instr uctions .
(01L) Luxur y-Lift ® Power Recliner
Assembly Details:
F I G U R E 2
F I G U R E 4
F I G U R E 5
F I G U R E 3
Back
Bracket Locking
Lever
Locked
Position
(01L) Luxur y-Lift ® Power Recliner
Assembly Instr uctions:
Body
Bracket
Back Bracket
Motor
Extension
Wire
Rear
Rail
Motor
Extension
Connector
Power
Transfor mer
Connector
7 6
F I G U R E 1
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
WARNING
WARNING
WARNING