La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 10)

19 18
-- To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
1. Install the back.
• Lay the back across the ar ms of the body. Lift the back at a slight angle
and align the brackets on the back with the brackets on the body (F IGURE 1).
• Lower the back onto the body, making sure the back and body brackets
are completely engaged.
• To make sure the back is proper ly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F I G U R E 2). Remove the back and repeat the steps a bove.
• If you are una ble to install the back proper ly contact your La-Z-Boy ®
dealer for assistance.
• Lock the brackets by using a screwdr iver to push down the locking lever s
(F I G U R E 3).
NOTICE:
Do not plug the transformer in until instructed.
2. Locate and identify the connector s . Do not connect until instr ucted.
• Lift the lower outside back upholster y cover to view the connector s .
• The two unconnected rectangular connector s are the Back Heat
connector s (F I G U R E 4).
• The two locked rectangular connector s are the Seat Heat connector s
(F I G U R E 4).
• The round connector attached to the rear base is the Motor Extension
Wire connector (F I G U R E 4).
3. Connect the Back Heat.
• Align the locking clip and locking edge of the Back Heat connector s .
Push the connector s together until they lock (F I G U R E 5).
4. Carefully cut the ca ble tie connecting the rear rail to the rear base. See
( F I G U R E 4) for location of the rear rail and rear base.
- To reduce the risk of minor injury:
• Once the back is installed, the outside back upholster y cover must be
secured in place at all times .
5. Attach the lower outside back upholster y cover.
• Keeping hands away from the inter nal frame par ts , pull the lower outside
back upholster y cover down and fir mly press the fastening ta pe on the
back upholster y cover to the fastening ta pe on the body ( F I G U R E 6).
-- To reduce the risk of serious injury:
• Check the condition of the power transfor mer s , electr ical cords , plugs
and connector s monthly. Keep the power transfor mer and electr ical
cords away from heat sources . Never operate the unit with a damaged
power transfor mer, electr ical cord, plug or connector. Contact your
La-Z-Boy ® dealer for ser vice.
(Assembly Instructions Continued)
(1LH) Luxur y-Lift ® Power Recliner with Heat
Assembly Instr uctions:
(1LH) Luxur y-Lift ® Power Recliner with Heat
Assembly Details:
F I G U R E 4 F I G U R E 3
F I G U R E 2 F I G U R E 1
Frame
Parts
Back Heat
Connection
Fastening
Ta pe
F I G U R E 5 F I G U R E 6
Body
Bracket
Back Bracket Back and body brackets on this side are not
engaged. Remove the back and reinstall.
Motor Extension
Wire Connector
Back Heat
Connectors
Seat Heat
Connection
Rear Rail
Rear Base
Back
Bracket Locking
Lever
Locked
Position
WARNING
WARNING
CAUTION