Kontron KBox C-101 - Manual (Page 42)

11. Control Cabinet Mounting KBox C-101 – User’s Guide (Version 2.00)
11.1. DC Power Connection
The KBox C-101 is connected by a Phoenix connector to a DC power source via a DC power supply wiring (only the Phoenix
power plug terminal is included).
The KBox C-101 is delivered with a DC power plug terminal (3-pin Phoenix connector). For DC connection prepare the
connecting wires using the supplied Phoenix plug terminal: PSC 1,5/ 3-F.
2 1 3
5
4
Fig. 36: Phoenix power plug terminal
1 3-pin Phoenix plug terminal
2 Cover over the slotted pan head screws
3 Location for inserting the functional earth wire
4 Location for inserting the “24V” wire
5 Location for inserting the “0V” wire
11.1.1. Cabling
For the pin assignment Phoenix power plug terminal refer to the subsection 7.3.1 “X101 - Power Input Connector”.
1. Cut the required length three isolated wires (1 mm2) AWG18 and strip each end 5 –7 mm.
2. Twist the striped wire-ends and provide them with ferrules.
3. Open the cover (Fig. 36, pos. 2) to have access to the slotted pan head screws.
4. Loosen the three slotted pan head screws of the DC plug terminal far enough so that you can insert the end of the
prepared wires.
5. Insert the wires into the corresponding clamp of the Phoenix plug terminal. Make sure that you have the right polarity
of the connection [refer to Fig. 36, Fig. 12 or subsection 18.1.1, (X 101) Power Input Connector].
6. Fasten the screws to secure the wires into the clamps of the plug terminal.
7. Close the cover (Fig. 36, pos. 2).
40 www.kontron.com