Kontron CP305 - Manual (Page 33)

CP305 Introduction
ID 1035-7168, Rev. 2.0 Page 1 - 13
P R E L I M I N A R Y
1.7 Kontron Software Support
Kontron is one of the few CompactPCI and VME vendors providing inhouse support for most
of the industry-proven real-time operating systems that are currently available. Due to its close
relationship with the software manufacturers, Kontron is able to produce and support BSPs and
drivers for the latest operating system revisions thereby taking advantage of the changes in
technology.
General
Mechanical 3U, 4HP, CompactPCI compliant form factor
Power Consumption typ. 10 W
For further information, refer to Chapter 5.
Temperature Range Operational: 0°C to +60°C Standard
-40°C to +80°C Extended (without hard disk and in the appro-
priate system environment)
Storage: -55°C to +85°C Without hard disk and without battery
-40°C to +65°C With hard disk and without battery
Climatic Humidity 93% RH at 40°C, non-condensing (acc. to IEC 60068-2-78)
Dimensions 100 mm x 160 mm
Board Weight 320 grams (4HP variants with heat sink, with front panel but without mezzanine
boards)
Battery 3.0V lithium battery for RTC with battery socket.
Recommended type: CR2025
Temperature ranges:
Operational (load): -20°C to +70°C typical (refer to the battery manufacturer’s
specifications for exact range)
Storage (no load): -55°C to +70°C typical (no discharge)
Note ...
For a description of the additional 8HP version interfaces, refer to the Techni-
cal Specifications table in Appendix A, CP305-HDD module.
Table 1-2: CP305 4HP Version Main Specifications (Continued)
CP305 SPECIFICATIONS
Note ...
When a battery is installed, refer to the operational
specifications of the battery as this determines the
storage temperature of the CP305 (See "Battery"
below).
Note ...
When additional components are installed, refer to
their operational specifications as this will influence the
board’s operational and storage temperature.