Kontron COMe-mTT10 - Manual (Page 74)

COMe-mTT10 / BIOS Operation
USB Configuration
Feature Options Description
Legacy USB Support Enabled
Disabled
AUTO
Enables Legacy USB support. AUTO option disables
legacy support if no USB devices are connected.
DISABLE option will keep USB devices available only for
EFI applications.
EHCI Hand-off Enabled
Disabled
This is a workaround for OSes without EHCI hand-off
Support. The EHCI ownership change should be claimed
by EHCI driver
USB Beep Enabled
Disabled
Send speaker beep for device attach / detach
Device transfer time-out 1 sec
5 sec
10 sec
20 sec
The time-out value for Control, Bulk and Interrupt
transfers
Device reset time-out 10sec
20sec
30sec
40sec
USB mass storage device Start Unit command time-out
Device power-up delay Auto
Manual
Maximum time the device will take before it properly
reports itself to the Host Controller. 'Auto' uses default
value: for a Root port it is 100ms, for a Hub port the
delay is taken from Hub descriptor
Device power-up delay in seconds 5 Delay range is 1..40 seconds, in one second increments
74