Kontron MSM800XEL - Manual (Page 41)

MSM800XEV/XEL / Connectors & Jumpers
www.kontron.com 39
5.2 Jumpers
The following table shows the location of all jumper blocks on the MSM800 board. The numbers shown in this figure
are silk screened on the board so that the pins can easily be located. This section refers to the individual pins for these
jumpers. The default jumper settings are written in bold.
Attention! Some jumpers are soldering bridges; you will need a miniature soldering station with a vacuum pump.
5.2.1 The Jumpers on the MSM800XEV/XEL
Settings written in bold are defaults!
Jumper Structure 1-2 / open 2-3 / closed Remarks
J1 Compact Flash select Slave Master Top
J2 Power On Switch Connect push button to X1 pin 6 always on Top
J5 LCD VDD 3.3V 5V Bottom
J6 LCD BKL (Backlight) 5V 12V Bottom
J7 CMOS/EEPROM reset Normal function Reset Top
J8 WOL (Wake on LAN) Enable Disable Bottom, since V1.2
Refer to Section 9.4 for important information!
Before Version 1.2, Jumpers 5 and 6 were located on the top of the board.
The 12V will not be generated on the board but must be supplied from an external PSU through connector
X1 pin4.