8graphics interface, 1 crt connector, 2 flat panel connector – Kontron MOPSlcdLX User Manual
Page 18

KTD-S0005-C Page
14
Graphics
Interface
MOPSlcdLX User's Guide
8
Graphics Interface
The graphics accelerator supports CRT monitors and a variety of LCD panels with single clock, color depths
of 18/24 bit and resolutions up to 1920x1440 for CRT and XGA (1024x768) for LCD.
8.1
CRT Connector
The CRT monitor interface is available through the X12001 connector (6 pins). To have the signals available
on a standard DSUB15 CRT monitor connector an adapter cable is required. A 15 pin DSUB cable is avail-
able from KONTRON (KAB-VGA-2, part number 96053-0000-00-0).
Header
Pin
Signal Name
Function
DSUB15
1
HSYNC
Horizontal sync
13
2
VSYNC
Vertical sync
14
3
GND
Ground
5 - 8
4
BLUE
Blue video signal
3
5
GREEN
Green video signal
2
6
RED
Red video signal
1
8.2
Flat Panel Connector
The LVDS interface for the flat panel is available through the X12000 connector (40 pins) on the top side of
the board. The implementation of this subsystem complies with the JILI specification of KONTRON Techno-
logy A/S. A variety of cables for different display types are available from KONTRON. Please refer to the
actual cable list on the KONTRON website for part numbers and cable names.
When using a LCD additional voltages may be required to drive the displays logic and supply the backlight
converter. The display logic may require +5V or +3.3V, backlight converters usually are +5V or +12V types.
When using a KONTRON JILI cable you do not need to determine such configurations. Display logic voltage
come preconfigured on the JILI cable. On occasion backlight voltage has to be adjusted on the cable. Even
though the MOPSlcdLX is a +5V only board you need to supply the +12V for the backlight converter addi-
tionally when using such a converter type.