Sconf save reset, Sconf status, U-boot usage am4150 u-boot bootloader – Kontron AM4150 U-Boot Bootloader User Manual
Page 38
U-Boot Usage
AM4150 U-Boot Bootloader
Page 38
ID 1052-5678, Rev. 1.0
P R E L I M I N A R Y
6.2.2.4
sconf save reset
Finally, the configuration must be saved with “sconf save”. The “sconf save” command stores
the settings but does not activate them. To activate the settings, use the “sconf save reset”
command.
6.2.2.5
sconf status
To determine if a system power cycle is required, invoke the “sconf status” command. The fol-
lowing example shows that a system power cycle is required.
The following is an example of the output shown after a successfully completed system power
cycle.
=> sconf save reset
Saving: #######
U-Boot ...
...
=>
=> sconf status
Configuration (Activation) Status:
Module is running:
managed (E-Keying)
sconf disables E-Keying:
no
sconf deactivated by DIP-SW:
no
Configuration is not active:
Save operation required:
no
Power On Reset required:
no
System Power Cycle required:
yes
Active AMC Base Configuration:
n.a.
Stored AMC Base Configuration:
2
‘New’ AMC Base Configuration:
2
=>
=> sconf status
Configuration (Activation) Status:
Module is running:
managed (E-Keying)
sconf disables E-Keying:
no
sconf deactivated by DIP-SW:
no
Configuration (stored) is active:
Stored AMC Base Configuration:
2
=>