Kontron AM4150 U-Boot Bootloader - Manual (Page 37)

AM4150 U-Boot Bootloader U-Boot Usage
ID 1052-5678, Rev. 1.0 Page 37
P R E L I M I N A R Y
6.2.2.2 sconf select
To change the setting, invoke the “sconf select” command.
Example:
6.2.2.3 sconf set
The setting of the chosen base configuration can be changed via the “sconf set” command. If
the “sconf set” command is invoked without parameters, all changeable options are shown. In
the following example, first, all possible settings are shown, and then the Ethernet interface
FM1@DTSEC4 is changed from the AMC port 1 to the front Ethernet connector J2 (GbE B).
=> sconf select 2
New base configuration 2
=>
=> sconf set
Board’s Port Configuration:
Option / Setting | Value # command, option parameter>
-------------------------------------------------------------
DTSEC4 routing : port1 # sconf set dtsec4
SRIO Sys.Size : large # sconf set srio
SRIO mode : agent # sconf set srio
AMC Port Activation / Forced settings (ignoring E-Keying):
Option / Setting | Value # command, option parameter>
-------------------------------------------------------------
Port 2 : auto # sconf set port 2 < auto | disable | enable>
Port 4 : auto # sconf set port 4 < auto | disable | enable>
speed : @5.0 # sconf set port 4 < @5.0 | @2.5 >
Port 8 : auto # sconf set port 8 < auto | disable | enable>
speed : @5.0 # sconf set port 8 < @5.0 | @2.5 >
Note: A port’s speed configuration becomes effective if the port is
enabled when running the module in unmanaged mode or the port is
forcibly enabled (i.e. not set to ‘auto’) in managed mode.
=> sconf set dtsec4 front
=>