Kontron AM4150 U-Boot Bootloader - Manual (Page 36)

U-Boot Usage AM4150 U-Boot Bootloader
Page 36 ID 1052-5678, Rev. 1.0
P R E L I M I N A R Y
6.2.2 Example of sconf Command Usage
6.2.2.1 sconf info
To get an overview of the possible interface configurations, invoke the “sconf info” command.
=> sconf info
List of available base configurations:
**< >** Stored base configuration
--[ ]-- ‘New’base configuration (work in progress)
========+-============================================================
Base | Port 0 Port 1 Port 2 Port 3 Port 4 Port 8
Config | ..7 ..11
========+-============================================================
|
**[ 0]**| GbE [GbE] SATA -- SRIO [@5.0] SRIO [@5.0]
|
< 1> | GbE [GbE] SATA -- SRIO @3.125 SRIO @3.125
|
< 2> | GbE [GbE] SATA -- SRIO [@5.0] GbE [2x1]
|
< 3> | GbE [GbE] SATA -- PCIE [Gen.2] PCIE[Gen.2]
|
< 4> | GbE [GbE] SATA -- PCIE [Gen.2] GbE [2x1]
|
< 5> | GbE [GbE] SATA -- PCIE [Gen.2] PCIE,GbE,[-],-
|
Note: [GbE] indicates that the DTSEC4 used can be redirected to the
front panel connector J2 (GbE B) or optionally to AMC Port 10 for
configurations which provide GbE interfaces in the Fat Pipes Region,
Port 8 or Port 9.
Board’s Port Configuration:
Option / Setting | Value # command, option parameter>
-------------------------------------------------------------
DTSEC4 routing : port1 # sconf set dtsec4
SRIO Sys.Size : large # sconf set srio
SRIO mode : agent # sconf set srio
AMC Port Activation / Forced settings (ignoring E-Keying):
Option / Setting | Value # command, option parameter>
-------------------------------------------------------------
Port 2 : auto # sconf set port 2 < auto | disable | enable>
Port 4 : auto # sconf set port 4 < auto | disable | enable>
speed : @5.0 # sconf set port 4 < @5.0 | @2.5 >
Port 8 : auto # sconf set port 8 < auto | disable | enable>
speed : @5.0 # sconf set port 8 < @5.0 | @2.5 >
Note: A port’s speed configuration becomes effective if the port is
enabled when running the module in unmanaged mode or the port is
forcibly enabled (i.e. not set to ‘auto’) in managed mode.
=>