5 technical specification, Technical specification - 10, Introduction am5020 – Kontron AM5020 User Manual
Page 28
Introduction
AM5020
Page 1 - 10
ID 1043-6198, Rev. 1.0
P R E L I M I N A R Y
1.5
Technical Specification
Table 1-2:
AM5020 Main Specifications
AM5020
SPECIFICATIONS
Processor and Memory
CPU
The AM5020 supports the following microprocessors:
•
Intel® Core™ i7-610E (SV) processor with ECC, 2.53 GHz, 4 MB L3 cache
•
Intel® Core™ i7-620LE (LV) processor with ECC, 2.0 GHz, 4 MB L3 cache
Further processor features:
•
Two execution cores
•
Intel® Hyper-Threading Technology (Intel® HT Technology)
•
Intel® 64 Architecture
•
Intel® Turbo Boost Technology
•
Intel® Intelligent Power Sharing (IPS)
•
System Memory interface with optimized support for dual-channel
DDR3 SDRAM memory with ECC at 1066 MHz
•
Integrated 2D and 3D Graphics Engines
•
DMI and FDI interfaces to the Intel® QM57 chipset
•
One x16 PCI Express 2.0 port operating at 2.5 GT/s
Please contact Kontron for further information concerning the suitability of
other Intel processors for use with the AM5020.
Memory
Main Memory:
•
Up to 8 GB, dual-channel DDR3 SDRAM memory with ECC running at
1066 MHz
Cache Structure:
•
64 kB L1 cache for each core
•
32 kB instruction cache
•
32 kB data cache
•
256 kB L2 shared instruction/data cache for each core
•
4 MB L3 shared instruction/data cache shared between both cores
Flash Memory:
•
Two redundant SPI flash chips (2 x 8 MB) for uEFI BIOS controlled by
the MMC
Mass Storage Device:
•
Up to 32 GB NAND flash via an onboard SATA Flash module
Serial EEPROM with 64 kbit
Chi
ps
et
Intel® QM57
Mobile Intel® QM57 Express Chipset:
•
Two x4 or eight x1 PCI Express 2.0 ports operating at 2.5 GT/s
•
SATA host controller with six ports, 3 Gbit/s data transfer rate and
RAID 0/1/5/10 support
•
USB 2.0 host interface with up to 14 USB ports available (only two ports
are used on the AM5020)
•
SPI flash interface support
•
Low Pin Count (LPC) interface
•
PCI interface, 32-bit/33 MHz (not used on the AM5020)
•
Power management logic support
•
Enhanced DMA controller, interrupt controller, and timer functions
•
System Management Bus (SMBus) compatible with most I²C™ devices
•
DMI and FDI interfaces to the processor
•
High Definition Audio Interface (not used on the AM5020)
•
Analog display port (not used on the AM5020)
•
Three digital display ports (only one port is used on the AM5020)
•
Integrated RTC