Kontron AM5020 - Manual (Page 25)

AM5020 Introduction
ID 1043-6198, Rev. 1.0 Page 1 - 7
P R E L I M I N A R Y
1.4.2 Front Panel
Figure 1-2: AM5020 Front Panel
AM5020
0
1
2
3
For further information on the LEDs used on the AM5020, refer to Chapter
2.10.1, “Front Panel LEDs”.
Note ...
If the ULED 0..3 are lit red during boot-up, a failure is indi-
cated before the uEFI BIOS has started. For further infor-
mation, please contact Kontron.
Note ...
The AM5020 is also available without retaining screws on the
front panel.
LED1 (red): Out-of-Service LED
LED2 (red/green): Health LED
HS LED (blue): The hot swap indicator provides basic feed-
back to the user on the hot swap state of the
module. The HS LED states are off, short
blink
, long blink, and on.
Module LEDs
ULED3 (red/green): AMC Ethernet port A link signal status, AMC port 0
(green) + POST
ULED2 (red/green): AMC Ethernet port B link signal status, AMC port 1
(green) + POST
ULED1 (red/green): SATA channels active (green) + POST
ULED0 (red/green): POST
User-Specific LEDs 3 ... 0
Serial Connector
Gigabit Ethernet Connector
USB Connector
DVI-D Connector
Connectors