Kontron KTQ67-FLEX - Manual (Page 104)

KTQ67 Users Guide
KTD-N0829-G Page 104
Function Selection Description
Terminal Type
VT100
VT100+
VT-UTF8
ANSI
Emulation: ANSI: Extended ASCII char set.
VT100: ASCII char set. VT100+: Extends
VT100 to support color, function keys, etc. VT-
UTF8: Uses UTF8 encoding to map Unicode
chars onto 1 or more bytes.
Bits per second
9600
19200
38400
57600
115200
Select serial port transmission speed. The
speed must be matched on the other side. Long
or noisy lines may require lower speeds.
Data Bits 7, 8 Data Bits
Parity
None
Even
Odd
Mark
Space
A parity bit can be sent with the data bits to
detect some transmission errors.
Even: parity bit is 0 if the num of 1’s in the data
bits is even.
Odd: parity bit is 0 if the num of 1’s in the data
bits is odd.
Mark: parity bit is always 1.
Space: parity bit is always 0.
Mark/Space do not allow error detection.
Stop Bits
1
2
Stop bits indicate the end of a serial data
packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit.
Communication with slow devices may require
more than 1 stop bit.
Flow Control
None
Hardware RTS/CTS
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a ´stop´ signal can be sent to
stop the data flow. Once the buffers are empty,
a ´start ‘signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
VT-UTF8 Combo Key
Support Disabled
Enabled Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
Recorder Mode
Disabled
Enabled On this mode enabled only text will be send.
This is to capture Terminal data.
Resolution 100x31
Disabled
Enabled Enables or disables extended terminal
resolution.
Legacy OS Redirection
Resolution 80x24
80x25 On Legacy OS, the Number of Rows and
Columns supported redirection.
Putty Keypad
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Select FunctionKey and KeyPad on Putty.
Redirection After BIOS
POST Always Enable
BootLoader
The settings specify if BootLoader is selected
than Legacy console redirection is disabled
before booting to Legacy OS. Default value is
Always Enable which means Legacy console
Redirection is enabled for Legacy OS.
BIOS - Advanced